Upgrading to led downlights


LED downlights use far less power than old halogen downlights for a similar amount of light, so they cost less to run. Before you upgrade, check five things: colour, brightness, beam angle, whether the fitting can be covered by insulation, and whether your dimmers will work with the new lights.
Work out your own saving first, then use this as your checklist.
How much can LED downlights save?
It depends on how many lights you have, the wattage of your old globes, the wattage of the new LEDs, how long they run and what you pay for power. Halogen downlights are often 50 watts. Many LED downlights are under 10 watts. Use the calculator above with the numbers from your own globes and bill.
1. Pick the right colour
LED colour is measured in kelvin. Lower numbers, around 3000K, give a warm, cosy light. Higher numbers, around 4000K and up, give a cooler, brighter white. Many homes use warm white in living areas and cooler white in kitchens, laundries and garages. Most quality downlights now come dimmable and tri colour, so you can choose between warm white, cool white and daylight with a switch on the fitting. That means you can change your mind later without replacing the light.
2. Check the brightness
Brightness is measured in lumens, not watts. When you compare lights, compare lumens. Too few lights or too low a lumen rating can leave a room dim.
3. Look at the beam angle
A narrow beam lights a spot. A wide beam spreads light across the room. Most homes suit a wider beam, so you do not end up with bright circles and dark patches.
4. Choose IC rated fittings
IC rated downlights, often labelled IC 4, are designed to be covered by ceiling insulation. That helps keep your insulation working, because it does not need big gaps cut around each light. Ask your electrician about it when you upgrade.
5. Make sure the dimmers match
Old dimmers made for halogens can make LEDs flicker or buzz. If you have dimmers, check the new lights are dimmable and the dimmer suits LEDs. An electrician can swap the dimmer if needed.
In NSW, replacing downlight fittings is electrical work for a licensed electrician. Learn more about our lighting work.
Common questions
Are LED downlights worth it?
For most homes, yes. They use far less power than halogens for similar light. Use your own globe wattage, hours and power price to see your saving.
What does IC 4 mean on a downlight?
It is a rating that shows the downlight is designed to be covered by ceiling insulation, which helps keep the insulation working.
Ready to upgrade your downlights?
Oztech Sparks has licensed electricians who upgrade homes and businesses to LED downlights across Sydney Metro and the Illawarra. Send an enquiry below, or call 1300 698 324.




Comments